Note that some Baintech, CTEK, GME & Vetus products are suffering shipping delays due to issues at the suppliers' warehouses.
Victron Non-inverting remote on-off cable
Use this cable to connect the following products to the VE.Bus BMS:
- Skylla-TG all models
The cable translates the remote on/off driver logic from the VE.Bus BMS (normally high, and open circuit in case of alarm) to the logic needed by above products: active pull down to switch off.
| Part Number |
|---|
| VIC-ASS030550200 |
Victron
Victron VE.Direct Non Inverting Remote On-Off Cable Use this cable to remotely control BlueSolar and SmartSolar MPPT charge controller models. Note that it's not necessary to use this cable on...
Victron
Victron Inverting Remote On-Off Cable The Inverting remote on-off cable is intended for products which require active pull down of the remote control terminal to switch on, while the source signal...
Victron
Victron Skylla-i Remote On-Off Cable Use this cable to connect a Skylla-i to a VE.Bus BMS. The VE.Bus BMS will then disable the Skylla-i charger when the batteries are fully charged...
Victron
Victron Orion-Tr Isolated DC-DC Charger remote cable In the Orion-Tr Isolated DC-DC Chargers the remote on/off circuit is referenced to the primary battery. The Orion-Tr DC-DC Charger Isolated...
Victron
Remote Panel for BlueSolar PWM-Pro. Features Warning LED The warning indicator LED flashes in case of failure of the connected charge controller. Audible alarm The audible failure alarm can be...
