Rigging Gear

Ronstan D-Splicer Scissors, D20 Designed to cut modern technical fibres such as Dyneema® and Vectran® Features Ideal for Aramid, Dyneema® and other modern fibres. Blade edges hardened and hollow-ground for long lasting edge...

Ronstan Pelican Hook, Threaded Eye 6.4mm (1/4") Eye Diameter. 1/4" RH Thread, sliding sleeve lock. The sliding sleeve offers wide opening, and quick release and tensioning. 6.4mm (1/4") diam. hole.   Range offers suitability for...

Ronstan Ceramic Rigging Knife Designed to cut technical fibres such as Dyneema® and Vectran®, the ceramic knife stays sharp much longer than a steel blade. A must-have in any rigging kit. These ceramic knives are very sharp and excellent for...

Ronstan Flared Saddle 10mm Clearance Stainless Steel, Flaired Saddle, stamped, 10mm Clearance   Grade 316 stainless steel Part Number RON-RF96

Ronstan Pelican Hook, Swage End Suits 4mm (5/32") Wire 1/4" RH Thread, sliding sleeve lock, The sliding sleeve offers wide opening, and quick release and tensioning. Suits 4mm (5/32") diam. wire.   Range offers suitability for all...

Ronstan Flared Saddle 4.8mm Clearance Stainless Steel Saddle, 4.8mm Clearance   Grade 316 stainless steel Part Number RON-RF94A

Ronstan Flared Saddle 6mm Clearance Stainless Steel Saddle, 6mm Clearance Can be used in conjunction with spring RF319 for stand up block configuration   Grade 316 stainless steel Part Number RON-RF94

Harken Vang-Master 1 Standard Vang-Master rigid vangs are available for boats with vang fittings on the boom and mastbase. Typical boat lengths: 5.5 – 7.9 m (18'-26') Weight 1.25kg Pin center length (closed) 813mm Pin center...

Use the 237 and 339 where there is little deflection in the line such as when routing a spinnaker pole fore guy aft along the cabin house. Note: DO NOT use Harken equipment for human suspension unless product is specifically certified and labelled...

The 433 and 394 dinghy clew hooks are designed for Lasers and other loose-footed dinghies. They install permanently on the boom and allow you to instantly attach and adjust your sail in high wind and waves. Note: DO NOT use Harken equipment for...

The 433 and 394 dinghy clew hooks are designed for Lasers and other loose-footed dinghies. They install permanently on the boom and allow you to instantly attach and adjust your sail in high wind and waves. Note: DO NOT use Harken equipment for...

Use the 237 and 339 where there is little deflection in the line such as when routing a spinnaker pole fore guy aft along the cabin house. DO NOT use Harken equipment for human suspension unless product is specifically certified and labelled for...